Measures Inductance, Capacitance, and Resistance with secondary parameter (Q,D,R)

• Simultaneous 20,000/10,000 count display of the primary parameter (L, C or R)
• Secondary parameter of Q (quality), D (dissipation) or R (resistance)
• Set Hi/Lo limits using absolute values or percentage limits
• Parallel or Series equivalent circuit
• Automatic blown fuse indication
• Built-in test fixture or use external test leads

Optional chip component fixture for use with LCR200 LCR meter

Optional chip component fixture for use with LCR200 LCR meter. The LCR205 is useful for testing tasks like impedance evaluations on SMDs. The unit features three terminals for High, Low and Guard as well as an adjustment knob to secure measurement contacts to components being tested.

• Adjustment range: 0 to 0.375'' (0.95cm)
• Terminals: 3 blades (High, Low, Guard)
• Adjustment knob

Optional tweezers for use with LCR200 LCR meter

The LCR203 are SMD component tweezers for use with Extech's LCR200 LCR meter. These tweezers make it easy to test and sort simultaneously for single handed operation. Tweezers complete the circuit with components easier than separate test leads. Comes with a 6 month warranty.

• Cable length: approximately 22'' (56cm)
• Max component width: 0.75'' (19mm)
• Terminals: 3 banana plugs (High, Low, Guard)

Measures Inductance, Capacitance, and Resistance with secondary parameter (Q,D,R,P,ESR)

The LCR200 is a passive component LCR meter. Discover the tremendous value with a range of features that help this meter provide the precise measurements you need. See simultaneous 20,000/2,000 count display of the primary parameter on the high contrast backlit display. You can set Hi/Lo limits using absolute values or percentages. Open and Short Zero removes unwanted stray impedances from the measurement. Use the built-in test fixture or external test leads (included). The LCR200 has an Auto Power Off function that can also be disabled and a low battery indicator to alert you when to replace the batteries. Complete with test leads and 9V battery.

• Measures Inductance, Capacitance, and Resistance with secondary parameter Q (Quality), D (Dissipation), R (Resistance), P (Phase), ESR (Equivalent Series Resistance)
• Simultaneous 20,000/2,000 count backlit display of the primary parameter (L, C or R) with the secondary parameter
• Auto Select measurement function with 1kHz default test frequency
• Five test frequencies
• Set Hi/Lo limits using absolute values or percentage limits
• Relative mode function
• Parallel or Series equivalent circuit
• Auto power off, Low battery and overrange indicators
• Built-in test fixture or use external test leads
• Open and Short calibration removes unwanted stray impedances from the measurement
• Complete with test leads and 9V battery